Metris Inspect-X 1.6 doubles CT reconstruction speed
8/9/2009 11:28:00 AM
Metris, market-leading supplier of X-ray and industrial Computed Tomography systems, launches Inspect-X 1.6 software that boosts throughput by increased CT reconstruction speed and improved general system control. Following Metris' drive for continual X-ray and CT system improvement, Inspect-X 1.6 further enhances system usability and introduces a faster CT reconstruction engine and support of latest Perkin Elmer panels.
A brand new reconstruction engine increases sample throughput and reduces as such ''Time-to-Volume". Programmed to run on the system's graphical processing unit (GPU), the new engine doubles reconstruction speed on existing hardware.
In combination with the latest hardware on new systems, the reconstruction of a 1024 pixel cubed volume using 1800 images is completed in only 38 seconds, whereas reconstruction previously lasted 2 minutes. A 2048 pixel cubed volume using 3600 images is reconstructed in 18 minutes.
The Inspect-X 1.6 software also supports the new Perkin Elmer 1621 EHS (high speed panel) in addition to the 1621 and 1620 models it already supported.
The usability of the system has been improved on various levels; the sample load position is now user programmable so it can be re-used for repeated operations, the auto defocus function allows for higher-power operation without risking target damage. Also the CT wizard has improved to guide the user through the measurement process including up-front data quality verification, before spending valuable time on data reconstruction and analysis.
Finally, Inspect-X 1.6 has been improved on the basis of user feedback to further enhance software operation and interface look and feel.
